U-Line 2000 Series Guía para resolver problemas

®COMBO® MODELSREFRIGERATOR / FREEZER MODELSCOMBO® MODELSUSE AND CARE GUIDEREFRIGERATORFREEZER MODELSU-LINE.COMU-CO2175FB-00U-CO2175FS-00U-CO2175FS-01U

u-line.com 7Adjusting Air TemperatureCombo ModelsNOTICE• Adjust the set point temperature in single increments, and wait 24 hours for the temperature

8 u-line.comDrawersThe drawers should only be removed for servicing by a trained and certified repair personal.To p S t o r a g e B i nGrasp the bin

u-line.com 9Ice Maker OperationWhen the ice bucket is full, the ice making mechanism will shut off. However, the refrigeration system will continue to

10 u-line.comLevelingNOTICEUnit must be level, for proper door and ice maker (if equipped) operation. For Models with adjustable leveling feet:1. Use

u-line.com 11Removing and Installing GrilleWARNING!Disconnect electric power to the unit before removing the grille.WARNING!DO NOT touch the condenser

12 u-line.comDoor SystemsA portion of models covered in this guide use the “Self-Closing” door system while others use the standard door system. See t

u-line.com 13Door ReversabilityLocation of the unit may make it desirable to mount the door on the opposite side of the cabinet. Many doors are revers

14 u-line.comPrepare door for reinstallation.1. Remove plastic hole plug from top of door handle and reinstall on opposite side.2. With bottom of door

u-line.com 15Door Alignment and AdjustmentAlign and adjust the door if it is not level, or is not sealing properly. If the door is not sealed the unit

16 u-line.comInstall bottom hinge:1. If you have a plate hinge, reorient the pivot screw so it protrudes the opposite direction form the hinge. Remove

u-line.comFOR PRODUCT ASSISTANCE, CALL 1-800-779-2547MILWAUKEE, WI U.S.A.Serial/Serie:Model/Modele:HIGH SIDE DESIGN PRESSURE 300 PSILOW SIDE DESIGN PR

u-line.com 17Checking Drawer AlignmentThe unit’s drawers are aligned at the factory before shipment. However, their alignment could have been disturbe

18 u-line.comMinor Adjustment:Note: The mounting holes on the slide are slightly larger than the screws’ diameter. 1. Loosen one slide’s mounting scre

u-line.com 19To d e f r o s t :1. Disconnect power to the unit.2. For combo models remove all products from the interior.3. Remove ice bucket and dis

20 u-line.comCondensor CleaningInterval - Every Three MonthsTo maintain operational efficiency, keep the front grille free of dust and lint, and clean

u-line.com 21Before Calling for ServiceIf you think your U-Line product is malfunctioning, read the OPERATION section of this guide to clearly underst

®USE AND CARE GUIDE©2013 U-Line CorporationPublication Number 30265 4/2013 Rev.FThe American Built-In Undercounter Leader Since 1962U-LINE.COMBUILDING

Safety PrecautionsSafety Alert Definitions ...

u-line.com 1NOTICE• PLEASE READ all instructions before installing, operating, or servicing the appliance.• Proper installation procedures must be fol

2 u-line.comProduct FeaturesCombo® Model Features:Built-in or Freestanding. Provides custom look when built-in with no additional venting clearance ne

u-line.com 3Control SystemsA portion of models covered in this guide use an electronic touch control while others use a manual control system. See the

4 u-line.comChecking Product TemperatureTo check the actual product temperature in the unit.1. Partially fill a plastic (nonbreakable) bottle with wat

u-line.com 5Electronic Control Quick GuideTa s k To u c h To u c h Display CommentTurn ON/OFF Hold 10 seconds Release when °F flashes. or Adjust Te

6 u-line.comAir FlowNOTICEThe unit requires proper air flow to perform at its highest efficiency. Do not block the front grille or internal fans at an