U-Line CLR2160 Guía para resolver problemas descargar pdf (Pagina 10)

8 U-Line Ice Maker

Clear Ice Maker Cleaning Cycle

Interval - Every 3 Months

To maintain operational efficiency, clean the unit every three

months (depending on water conditions, more or less frequent

cleaning may be necessary). If the ice maker requires more

frequent cleaning, consult a qualified plumber to test the water

quality and recommend appropriate treatment.

IMPORTANTIMPORTANT

Wear rubber gloves and safety goggles and/or face shield

when handling Ice Machine Cleaner.

CAUTION

Use only U-Line Ice Machine Cleaner (Part No. 37050,

available from your dealer or direct from your local parts

distributor. To locate a parts distributor near you, visit

www.U-LineService.com. It is a violation of federal law to

use this solution in a manner inconsistent with its labeling.

Use of any other cleaner can ruin the finish of the

evaporator and will void the warranty. Read and

understand all labels printed on the package before use.

U-Line Ice Machine Cleaner is used to remove lime scale and other

mineral deposits. Refer to the following steps to initiate the self-

cleaning cycle.

IMPORTANTIMPORTANT

• Model CLRCO2175 refrigerator will not operate during

the ice maker cleaning cycle. Remove all fresh food to

prevent spoilage.

• Model CLRCO2175 ice production after the first

harvest may take longer after the cleaning cycle since

restoring the refrigerator temperature will take

precedence over ice production. Once the refrigerator

reaches its set-point temperature, ice making will

resume.

CAUTION

Never use anything to force ice from the evaporator.

Damage may result.

1. Turn the ice maker off (allowing any ice to melt off of the

evaporator):

2. Remove all ice from the

storage bin.

3. Remove evaporator

cover.

4. Remove the standpipe

by lifting it up while using

a slight back and forth

motion to loosen it from

the drain hole. The

water in the reservoir

will flow down the drain.

5. Re-install the standpipe into the water trough.

6. Clean the Interior Bin as follows:

• Dilute one packet of CLR cleaner into two quarts of water.

• Using a sponge or cloth, clean interior of ice bin, tubing and

door. This cleaner will remove all mineral deposits and

other contaminants from the surfaces.

• Using a bottle brush, clean out the trough drain tube and

pump tubing where needed.

7. Turn unit on by touching the POWER icon

8. Place the unit into CLEAN mode by touching and holding the

POWER icon while pressing the LIGHT icon three times.

9. When water begins flowing over the evaporator (approximately

3 minutes), pour 1 packet of CLR cleaner into the water trough.

The cleaning process will last approximately 45 minutes.

10. Following the cleaning process, sanitize the ice bin with a dilute

bleach solution. (1 Tablespoon bleach per gallon of water).

Dilute 1 tablespoon bleach in 1 gallon of warm water. Apply this

solution to the entire inside of the storage area. Then rinse

thoroughly with water.

The unit will resume operation approximately 15 minutes after the

automated cleaning process is completed. The water fill valve will

energize, fill the water reservoir, and shut-off after three minutes.

The compressor begins to operate and water flows over the

evaporator assembly (ice cube tray). Initially, the water flow may

not be uniform, causing uneven sized cubes or water to spill into

the ice storage bin. This is a normal situation that will correct itself

within the first 24 hours of operation.

5 Clear Ice Maker

Evaporator cover

Standpipe

Evaporator

Water trough

Brush

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 19 20

Comentarios a estos manuales

Sin comentarios

U-Line CLR2160 Guía para resolver problemas Pagina 10

Comentarios a estos manuales

Relacionado con productos y manuales para Neveras U-Line CLR2160