U-Line CLR2160 Guía para resolver problemas descargar pdf (Pagina 8)

6 U-Line Product Operation

123 54

To check the actual product temperature in the unit.

1. Partially fill a plastic (nonbreakable) bottle with water.

2. Insert an accurate thermometer.

3. Tighten the bottle cap securely.

4. Place the bottle in the desired area for 24 hours.

5. Avoid opening the unit during the testing period.

6. After 24 hours, check the temperature of the water. If required,

adjust the temperature control in a small increment (See

ADJUSTING TEMPERATURE).

Causes which affect the internal temperatures of the

cabinet include:

• Temperature setting.

• Ambient temperature where installed.

• Installation in direct sunlight or near a heat source.

• The number of door openings and the time the door is open.

• The time the internal light is illuminated. (This mainly affects

product on the top rack or shelf.)

• The front grille or condenser are obstructed.

Checking Product Temperature

Interior Lighting

Normal Operation. Opening the door will cause the interior of

the cabinet to illuminate.

Use the LIGHT icon (5) on the control panel to change the lighting

functions.

Blackout (Sabbath) Mode. The interior of the cabinet and

control display remains darkened until reset. (Blackout (Sabbath)

Mode is not Star K certified).

To turn the lights and display OFF.

1. Press and hold the LIGHT icon (5) for ten seconds and release

(the °F symbol will flash briefly at the end of the ten second

period).

2. The interior light and control display (3) will go dark until the

mode is reset.

3. NOTE: Although the display will not be visible, the temperature

controls in the unit remain active, and preserve the interior

temperature.

To exit the Blackout (Sabbath) Mode, repeat Step 1.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 19 20

Sin comentarios

U-Line CLR2160 Guía para resolver problemas Pagina 8