U-Line CLR2160 Guía de instalación descargar pdf (Pagina 8)

www.U-LineService.com 8 05/2007

CLR2160/CLRCO2175 Ice Makers

Other Site Requirements

Power Supply

The unit requires a grounded and polarized 115 VAC,

60 Hz, 15A circuit (normal household current). See

Electrical Specifications on Page 20.

Water Supply

The unit requires a 1/4” O.D. soft copper water supply

line. For more information see Page 15.

Drain

The unit’s generous 7-inch drain connection height

extends the distance the unit can be located from a

gravity drain. For more information see Page 15.

IMPORTANT

Drain can NOT be located directly below unit. Unit has a

solid base that will not allow unit to drain below itself.

Environmental Requirements

Many U-Line models are designed to operate in harsh

outdoor environments. Special considerations include the

following:

• The units are designed to operate between 50°F (10°C)

and 110°F (40°C). High ambient temperatures (110°F

[40°C] or higher) may reduce the unit’s ability to reach

low temperatures and may also reduce the ice

production rate for those models with ice makers.

• If the ambient temperature is expected to drop below

45°F (7°C), drain all water from the unit to prevent

freezing damage not covered by the warranty.

• For best performance, keep the unit out of direct

sunlight and away from heat generating equipment.

• For best performance and life outdoors, place under a

counter or provide shelter of some kind.

• In climates where high humidity and dew points are

present, condensation may appear on outside surfaces.

This is considered normal. The condensation will

disappear when the humidity drops.

Side-By-Side Installation

Instructions CLR2160

For a complete refreshment center, install your CLR2160

Clear Ice Maker beside a U-Line Refrigerator, Combo, or

Wine Captain Model (see Figure 14 for typical cut-out).

Note that each Side-By-Side Installation will be different.

• Cut-out width for a side-by-side installation is the total

of the widths listed under Cut-Out Dimensions in each

unit’s Installation Guide.

For example:

Placing a CLR2160 Clear Ice Maker next to a 2115 series

unit would require a cut-out width of:

15-3/16" + 15-3/16" = 30-3/8".

Placing a CLR2160 Clear Ice Maker next to a 2175 series

unit would require a cut-out width of:

15-3/16" + 24-3/16" = 39-3/8".

•

No trim kit is required. However, 1/4-inch space needs to

be maintained

between the units to ensure

unobstructed door swing.

• Units must operate from separate, properly grounded

electrical receptacles placed according to each unit’s

Electrical Specifications.

Acceptable

Location

Preferred

Location

for CLR2160

Receptacle

24"

34-1/4"

35-1/8"

1/4" Space

Between Appliances

Figure 14

Typical Side-By-Side Cut-Out

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 23 24

Comentarios a estos manuales

Sin comentarios

U-Line CLR2160 Guía de instalación Pagina 8

Comentarios a estos manuales

Relacionado con productos y manuales para Neveras U-Line CLR2160