U-Line CLR2160 Guía para resolver problemas descargar pdf (Pagina 12)

12 CLR2160, CLRCO2175

CAUTION

DO NOT use any type of cleaner on the condenser

unit.

4. Clean the condenser coil

(Figure 8, 2)

using a soft

brush with a “combing” action or vacuum cleaner. Do

not touch the condenser coil.

5. Position the grille to align the mounting screws with

the holes in the cabinet.

6. Secure, but do not over-tighten both grille screws.

7. Reconnect power to the unit.

Clear Ice Maker Maintenance

Self-Cleaning Cycle

Interval - Every Six Months

To maintain operational efficiency, clean the unit every six

months (depending on water conditions, more or less

frequent cleaning may be necessary). If the ice maker

requires more frequent cleaning, consult a qualified

plumber to test the water quality and recommend

appropriate treatment.

WARNING

Wear rubber gloves and safety goggles and/or

face shield when handling Ice Machine Cleaner.

CAUTION

Use only U-Line Ice Machine Cleaner (P/N 41978,

available from your dealer or direct from U-Line). It

is a violation of federal law to use this solution in a

manner inconsistent with its labeling. Use of any

other cleaner can ruin the finish of the evaporator

and will void the warranty. Read and understand all

labels printed on the package before use.

U-Line Ice Machine Cleaner is used to remove lime scale

and other mineral deposits. Refer to the following steps

to initiate the self-cleaning cycle.

IMPORTANTIMPORTANT

• The Model CLRCO2175 refrigerator will not

operate during the ice maker cleaning cycle.

Remove all fresh food to prevent spoilage.

• Model CLRCO2175 ice production after the first

harvest may take longer after the cleaning cycle

since restoring the refrigerator temperature will

take precedence over ice production. Once the

refrigerator reaches its set-point temperature, ice

making will resume.

IMPORTANTIMPORTANT

Never use anything to force ice from the

evaporator. Damage may result.

Figure 9

1. Turn the ice maker off (allowing any ice to melt off of

the evaporator) as follows:

a. Touch and hold the ON/OFF button (Figure 9, 1).

b. The display (Figure 9, 3) will switch from ICE to OFF

to confirm that the ice maker is off.

2. Remove all ice from the storage bin.

Figure 10

3. Remove inside front cover

(Figure 10, 1)

Figure 11

4. Remove the overflow tube

(Figure 11, 1)

by lifting it

up while using a slight back and forth motion to loosen

123 54

ULIN_0058_A

ULIN_0059_A

ULIN_0060_A

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 23 24

Comentarios a estos manuales

Sin comentarios

U-Line CLR2160 Guía para resolver problemas Pagina 12

Comentarios a estos manuales

Relacionado con productos y manuales para Neveras U-Line CLR2160