U-Line CLR2160 Guía para resolver problemas descargar pdf (Pagina 17)

CLR2160, CLRCO2175 17

5. Remove the two door closer inserts

(Figure 26, 1)

from

the existing bottom hinge and install as shown on the

new bottom hinge

(Figure 25, 1)

6. Remove existing bottom hinge (three screws) and

remount on opposite side TOP. Remove hinge screw pin.

7. Remove the plastic hole plug from the top of the door

to allow the pivot pin to be inserted in the new

location. Install the plug into the vacated hole on the

opposite side.

Figure 27

8. With bottom of door facing up, remove pivot plate

(two screws), flip over, and remount on opposite side of

door

(Figure 27)

Be sure notch in plate faces

center.

9. Holding door upright with top of door tilted forward,

place hole of door pivot plate on bottom hinge screw

pin/closer inserts

(Figure 25, 1)

10. Tilt top of door into position in top hinge and install top

hinge screw pin.

11. Install plastic screw plugs removed in Step 2 in old hinge

holes (three each, top and bottom).

Door Shelf Removal/Insertion

Figure 28

To remove the door shelf:

1. Grasp shelf in center, lift slightly, and tilt 15°-20°.

2. Carefully pull shelf off bosses

(Figure 28, 2)

To install the door shelf:

1. Holding shelf in center, align notches (Figure 28, 1) in

shelf with bosses (Figure 28, 2) in door.

2. Tilt shelf at a 15°-20° angle and slide onto bosses at the

desired location.

Glass Shelf Removal/Installation

Figure 29

1. Pull shelf out about 6" (Figure 29, 1) until back of

shelf clears the "hump" on the right-hand side.

2. Tilt right-hand edge of shelf up.

3. Remove shelf from unit by pulling out

(Figure 29, 2)

ULIN_0006_A

ULIN_0039_A

ULIN_0276_A

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 23 24

Comentarios a estos manuales

Sin comentarios

U-Line CLR2160 Guía para resolver problemas Pagina 17

Comentarios a estos manuales

Relacionado con productos y manuales para Neveras U-Line CLR2160