U-Line CLR2160 Guía para resolver problemas descargar pdf (Pagina 14)

14 CLR2160, CLRCO2175

b. Touch and release the DOWN ARROW (Figure

13, 2) button three times, then release the UP

ARROW button (Figure 13, 1).

c. The display (Figure 13, 3) will switch to “0” to

confirm the thickness adjustment mode has been

selected.

2. The factory setting is “0,” and the total range of

adjustment is -5 to +5. Use the UP ARROW button to

raise the setting and thicken the ice bridge, or the

DOWN ARROW button to lower the setting to thin the

ice bridge.

IMPORTANTIMPORTANT

Ice thickness adjustment should only be made one

increment at a time. Allow ice maker production to

stabilize for 24 hours before rechecking ice

thickness.

3. Touch and release the LIGHT

(Figure 13, 4)

button key

to exit the ice thickness adjustment mode.

4. Remove all ice from the storage bin.

Figure 14

5. Ice cubes in any given batch will vary, so it is necessary

to choose cubes from the sample area

(Figure 14, 1)

for comparison when making adjustments. If further

adjustments are desired, repeat Steps 1 through 4.

Drain Pump

Interval - Not Required

A drain pump, if installed, requires no routine

maintenance. To check its operation, pour 1 gallon of

cool, fresh water into the ice bin. The drain pump will run

and water should drain freely from the bin.

Leveling

IMPORTANTIMPORTANT

It is extremely important that Clear Ice models are

level. If not level, the ice mold will not fill evenly.

Figure 15

A unit that is not level can cause a reduction in ice rate,

uneven sized cubes or water spilling into the storage area,

which will cause the ice in the bin to melt prematurely

(Figure 15).

When checking the level, remember that floors near

drains have a tendency to slope towards the drain.

Figure 16

Use a level to check the levelness of the unit from front to

back and from side to side. Level should be placed along

top edge and side edge as shown (Figure 16).

Figure 17

6. If the unit is not level, adjust the feet on the corners of

the unit as necessary

(Figure 17)

7. Check the levelness after each adjustment and repeat

the previous steps until the unit is level.

ULIN_0063_A

ULIN_0047_A

ULIN_0043_A

ULIN_0044_A

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 23 24

Comentarios a estos manuales

Sin comentarios

U-Line CLR2160 Guía para resolver problemas Pagina 14

Comentarios a estos manuales

Relacionado con productos y manuales para Neveras U-Line CLR2160